Ricoh PRIPORT VT 2000 Series Service Manual page 235

28 February '91
5. Disconnect the connector [D] of the encoder.
6. Insert the gauge [A] into the hole of the gear [E].
7. Turn on the LED "--2" of the Image shift indicator on the operation panel.
Then gradually turn the shaft of the encoder [B] in the "0" position
direction and stop it as soon as the "0" position LED lights.
8. In the above condition, set the encoder and tighten the allen screw [F] to
mount the shaft of the encoder with the gear [E]. Then remove the gauge
[A] and connect the connector [C] of the image shift motor.
9. After adjustment, make prints to confirm the image position.
[D]
[F]
[C]
[B]
5-22
[E]
[A]