Ricoh PRIPORT VT 2000 Series Service Manual page 257

28 February '91
7.6 UPPER SECOND FEED ROLLER ADJUSTING
Purpose: To ensure that paper is fed between the drum and the pressure
roller without skewing.
1. Remove both front and rear covers.
2. Move the second feed roller sector gear fully clockwise, so that the upper
second feed roller [A] contacts the lower second feed roller.
3. Make sure that the clearance between the bushing [B] and the bushing
supporter [C] is 0.05 to 0.1 mm as shown.
4. If incorrect, loosen the screw [D] and adjust the clearance by moving the
bushing supporter.
5. After adjustment, make sure that the feed length of the second feed roller
is correct. (The feed length varies with the position of the bushing
supporter.)
[B]
[D]
5-44
[A]
0.05 -- 0.1 mm
[C]