Ricoh PRIPORT VT 2000 Series Service Manual page 259

28 February '91
7.8 PAPER FEED SECTOR GEAR STOPPER CLEARANCE
ADJUSTMENT
[G]
0.1 -- 0.5 mm
[H]
Purpose: To ensure that the paper feed roller starts rotating when the paper
1. Remove the rear cover.
2. With a spanner (10 mm), gradually turn the shaft [A] counterclockwise.
3. Make sure that the clearance between the sector pin [B] and the sector
stopper [C] is 0.1 to 0.3 mm after turning the sector gear [D] fully
clockwise.
4. If the clearance is incorrect, loosen the Allen screws [E] and adjust the
clearance by shifting the sector pin [B].
5. Manually depress the plunger of the paper feed solenoid [F], and make
sure that the clearance between the sector pin [G] and the sector stopper
[H] is 0.1 to 0.5 mm.
6. If the clearance is incorrect, loosen the screws [I] and adjust it by shifting
the paper feed solenoid bracket up or down.
[I]
[F]
feed solenoid turns on and stops rotating when the paper feed
solenoid turns off.
[A]
0.1 -- 0.3 mm
[B]
5-46
[D]
[C]
[E]