Install The Console; Connect Console To Mcu; Install Software - Polycom SpectraLink 6300 MCU Manual

Install the Console

Connect Console to MCU

Install Software

PN: 1725-36125-001_L.doc
Before the Operator's Console can be connected, the System
Controller card on the MCU must be installed and operational.
To connect the console, connect an RS-232 null modem cable from a
COM port on the console to either one of the
System Controller card in the MCU. The System Controller card has a
9-pin male connector.
Remote operation
Remote Operator's Console operation is accomplished by connecting
modems to both the PC and the MCU. The MCU modem must have
Hardware Flow disabled. The modem should be connected to the
COM port on the MCU.
Before you can use the computer as an Operator's Console you must
load the Operator's Console software and run the program. The
software is provided on a 3 1/2" floppy disk.
Before installing the software, make a backup copy of the disk using
a blank disk.
To install the software:
1. Place the disk in the 3 1/2" disk drive.
2. Create a directory called chk3000 on the PC's hard disk.
3. Copy the files from the disk to the chk3000 directory.
1
ports on the
RS-232
A
9