Polycom SpectraLink 6300 MCU Manual page 41

PN: 1725-36125-001_L.doc
The left side of the screen shows the detail for the T1 remote card
connected to this shelf at the near end.
The right side of the screen shows the detail for the T1 remote card at
the far end, in the remote shelf.
Brd, ROM, Fac, Dl, and RC
These are set at the factory.
Current T1 configuration version / current frequency lock
T1 V/Fll
loop adjustment.
Current delay (skew) on T1 A/B.
T1 Delay
Amount of time the remote card has been running.
RC Uptime
Remote card state. In normal function, state is
RC State
Reason for the last remote card reset.
Reset Reas
through
Alarms MCU T1 B
there will be an alarm message or reason listed next to the component.
See SpectraLink 6300 MCU: Maintenance and Diagnostics for
troubleshooting information.
Number of local IPC CRC errors.
IPC CRC
Number of local IPC overrun errors.
IPC OVR
Number of local IPC underrun errors.
IPC UNR
Highest level reached in IPC RX queue and number of times
IPC RX
queue overflowed.
Highest level reached in IPC TX queue and number of times
IPC TX
queue overflowed.
Version numbers of the system hardware.
If these components are in an alarm state,
System Status
.
Running
41