Polycom SpectraLink 6300 MCU Manual page 34

SpectraLink 6300 MCU: Operator's Console: SpectraLink 6000 System
34
Shows the status of the system configuration. During an
Sys Cfg State
update, the config passes through these states: dirty, erasing,
programming, and back to idle (blank). Dirty state remains for 60
seconds after the last change made. The erasing and programming
state lasts for around 50 seconds.
Amount of time the system configuration has been in the
Sys Cfg Time
cfg state.
The version of the Interface Module (port card)
PC Cfg Ver
configuration.
Shows the status of the Interface Module (port card)
PC Cfg State
configuration. During an update, the config passes through these
states: dirty, erasing, programming, and back to idle (blank). Dirty
state remains for 60 seconds after the last change made. The erasing
and programming state lasts for around 50 seconds.
Amount of time the Interface Module (port card) config
PC Cfg Time
has been in the cfg state.
Supervisor State Display – menu of options
From the
Supervisor State Display
menu of options for the selected shelf.
Displays details about this shelf (cabinet). See
Show Cabinet Detail
following section.
Displays menu of options for remote T1 card,
Remotecard Options
including editing Remote Shelf configuration, displaying remote card
details, clearing alarms for remote cards, and resetting remote cards.
Deletes a shelf (cabinet) from the system.
Delete Cabinet
Used to take the system down for system-wide
Lock System
maintenance or reconfiguration. A locked system does not allow new
calls to start, but allows existing calls to complete.
Used to bring the system back to normal state after it
Unlock System
has been in the locked state.
Immediately starts the Listen Verify diagnostic
Start Listen Verify
routine. Normally this routine is run automatically at the time set in
Configuration Display and Administration
Stations are installed and running.
Check Listen Verify Report
with possible problems. See Chapter 4 Diagnostics Procedures, section
Listen Verify Test.
screen (F1) press Enter to display a
. It should be run after all Base
Checks report and displays Base Stations
PN: 1725-36125-001_L.doc