Polycom SpectraLink 6300 MCU Manual page 22

SpectraLink 6300 MCU: Operator's Console: SpectraLink 6000 System
22
1. Press F8 to enter
Configuration Display and Administration
Enter to display menus for each field.
2. From the menu, use the mouse or arrow keys to select your
option.
If you are not sure of an entry, leave the default.
—
To change a selection press Enter, then enter the new value.
—
Select an alternate frequency sequence to be used by the
Frequency
system in cases of interference by other radio devices. Use the
frequency ranges shown on the display to select the best
interference avoidance pattern for your situation. Range is 1
through 7.
The number of seconds the system should wait
PT Disconnect
before disconnecting from the telephone line if the handset has
stopped communicating with any Base Station. This may happen
if the telephone is turned off or the user walks out of the coverage
area during a call. The allowed range is from 1 to 600 seconds.
Default value is 30.
(analog interface only) The time the system should
Flash Delay
wait after the "on-hook" flash signal ends before allowing other
keys to be transmitted to the host telephone system. The allowed
range is from .01 to 2 seconds. The value depends on the
requirements of the host telephone system.
(analog interface only) The length of time the
Flash Disconnect
system should be "on-hook" when the user presses the
during a call, or uses a macro that includes a Flash code. The
allowed range is from .01 to 2 seconds. The value depends on the
requirements of the host telephone system.
Used by Polycom engineering. Leave the default
Listen Average
entry (.10).
Used by Polycom engineering. Leave the default entry
Listen CRC
(.30).
Used by Polycom engineering. Leave the default
Listen Sig Pcnt
entry (0).
Signal compression type. Mu-law is standard
Companding Type
format in most host telephone systems in North America. A-law is
typically used in Mexico. If the companding type of the MCU does
not match the host telephone system's the handsets will have
distorted dial tone and unintelligible voice quality.
Sets the time at which the Listen Verify function
Listen Verify Time
will run automatically. This can be set to run once per day.
, then press
key
Start
PN: 1725-36125-001_L.doc