Polycom SpectraLink 6300 MCU Manual page 35

PN: 1725-36125-001_L.doc
Dump Listen Verify Report
file lisver.log in your working directory. Prompts to replace or
append the file.
Dump Portcard State/History Report
the file portcard.log in the working directory. Prompts to replace or
append the file.
Sets or re-sets the date and time for the system. The
Set Date and Time
system gets the date and time information from the PC connected to
the system.
Save Configuration Now
immediately save the configuration to non-volatile memory. Use
when configuration changes are made and you do not want to wait to
load the changes.
Dump System Configuration to PCS.CFG
configuration data for the system to a file for backup purposes. See
Chapter 5 Backups.
Load System Configuration from PCS.CFG
configuration data from a backup file to the System Controller card.
See Chapter 5 Backups.
Shows 12 lines of information about handsets. Also shows
PT Active
whether or not the configuration is active (System Controller card or
Interface Module) and if someone is dialed into the system. See
Chapter 3 System Status, section.
Clear Supervisor/Router Variable
following variables: Peak Hiway Fullness; Peak Missed Count; Reset
Count; RCU Timeslot Full Count; Router Peak; Router Overflow;
Router Collision.
Provides a menu of options to clear alarms for all
Clear Cabinet Alarm
shelf (cabinet) components appropriate to that shelf.
If alarms or variables reappear after being cleared, there is a
problem which must be diagnosed and resolved.
Writes the latest Listen Verify report to the
Writes the latest Portcard report to
Forces the System Controller card to
This function copies
This function copies
Provides a menu of options to clear the
System Status
35