Diagnostic Procedures; Listen Verify Test - Polycom SpectraLink 6300 MCU Manual

Diagnostic Procedures

Listen Verify Test

PN: 1725-36125-001_L.doc
Listen Verify is a daily Base Station test used to ensure that the Base
Stations are functioning properly.
This test requires that each Base Station in turn stop transmitting so
that it may listen to all the other Base Stations. Each Base Station must
hear at least one other Base Station and be heard by at least one other
Base Stations. This test occurs daily at the Listen Verify time set on the
Configuration Display and Administration
If a Base Station is physically isolated from other Base Stations, the
Listen Verify alarm can be disabled by configuring the Base Station as
, see Chapter 2 System Configuration, section Configure
isolated
Interface Modules (Port Cards)
(F4-Portcard Configuration Display
and Administration), under Configure Base Stations (RCUs).
Run Listen Verify on demand
The Listen Verify test can be run on demand. To do this:
1. From the
Supervisor State Display
2. From the menu, select
3. Check
Listen Verify Report.
screen (F8).
screen (F1), press Enter.
and press Enter.
Start Listen Verify
4
51