Pt Active Function- Handset Summary - Polycom SpectraLink 6300 MCU Manual

PT Active Function– Handset Summary
PN: 1725-36125-001_L.doc
Reason for last shelf card reset.
Reset Reas
: through
Alarms Control SW
shelf. If they are in an alarm state, there will be an alarm message or
reason listed next to the component. See SpectraLink 6300 MCU:
Maintenance and Diagnostics for troubleshooting information.
Version numbers of the system hardware. These
Brd, ROM, Fac and Dl
are set at the factory.
Software version number of the Shelf Controller.
CC
The screen shows up to 12 active items. An item can be :
PT Active
• An active handset. Each entry shows the port location, note
associated with the handset, extension, Base Station on which the
handset is communicating, and the Base Station's note.
• Indicates that someone else is using the other COM
UART Busy
port on the System Controller card.
•
PC or Sys CFG state
amount of time in that state.
These are sub-components of the
UART
Status may be ,
Dirty Erasing
System Status
, or , and
Programming
39