Polycom SpectraLink 6300 MCU Manual page 18

SpectraLink 6300 MCU: Operator's Console: SpectraLink 6000 System
18
The factory assigned serial number for this
Serial Number
telephone, located inside the battery compartment under the
battery. Double-check this number when it is entered. If the serial
number is entered incorrectly the telephone will not function and
will appear to be defective.
User name or any other information. Do not enter quotes (")
Note
in this field or an error message will display. The system does not
require an entry in this field but it is highly recommended.
Extension number or SPID (required for ISDN
Extension/SPID
lines). Must be numeric, cannot contain quotes (").
When information is correctly entered, select
Configure Base Stations (RCUs)
This procedure associates a Base Station with a specific port location.
It also assigns the Base Station's frequency offset, and allows you to
enter a description of the location. Refer to the completed Base Station
Location Form from SpectraLink 6300 MCU: Installation for locations
and circuit IDs of Base Stations.
1. Select the appropriate Cabinet/Portcard.
2. Use the arrow keys or mouse to position the cursor on the
be configured, and press Enter.
3. When the menu displays, scroll down to
press Enter.
4. At the pop-up menu, type the information for each Base Station.
The following screen shows the pop-up menu.
to save it.
SAVE
RCU
, and
Edit RCU (Base Station)
PN: 1725-36125-001_L.doc
to