Polycom SpectraLink 6300 MCU Manual page 37

PN: 1725-36125-001_L.doc
Amount of time the System Controller card has been
SC Uptime
running.
System Controller card state. In normal function, state is
SC State
.
Running
Shows which highways on this shelf are disabled or not
SC Hwy Dis
yet in use. Shows 10 dots (one for each card between slots 3 and 12). If
a dot ( )displays, the highway is ok or has been used. If a
.
the highway is disabled or not used yet. A
card plugged into a slot.
Supervisor UART. Used by Polycom engineering.
SC UARTs
through
Alarms - Router
shelf. If they are in an alarm state, there will be an alarm message or
reason listed next to the component. See SpectraLink 6300 MCU:
Maintenance and Diagnostics for troubleshooting information.
Version numbers of the system hardware. These
Brd, ROM, Fac and Dl
are set at the factory.
SC, CC, PC, RC, PC2, and PT
Controller card, Shelf Controller, Interface Module, and Remote Shelf
(if installed), Interface Module Type 2, and Wireless Telephone. The 1-
to 3-digit IDs of these can be different, but the 3-digit IDs of each
version number should be the same (e.g. 6.006, 7.006) except for the
PT, which may have an unrelated number.
Used by Polycom engineering.
Card Recvr
Number of IPC CRC errors detected by System Controller
IPC CRC
card.
Number of IPC overrun errors detected by System
IPC OverRun
Controller card.
Number of IPC receive queue full occurrences detected by
IPC RX Full
System Controller card.
Number of IPC transmit queue full occurrences detected by
IPC TX Full
System Controller card.
Cumulative number of problems with clock state.
Clock Errs
Source of clocks (
ClockState
if no T1 remote modules are present. Will be
Internal
remote modules are present and the Master Clock Cabinet parameter
has been changed.
displays if there is no
d
These are sub-components of the
Download
Software version numbers of the System
or
Internal External
System Status
displays,
d
). Should always be
if T1
External
37