Disk; Disk Management - Vitek Transcendent VT-TNR Series User Manual

VITEK Industrial Video Products – Transcendent Series NVRs

7.4 Disk

7.4.1 Disk Management

Disk Management
Ø
Click StartàSettingsàDiskàDisk Management to go to disk management interface. You can
view the NVR's disk number and disk status and so on in the interface. Click "Format" to format
the HDD.
Data Encryption:
① Click "Data Encrypt".
② Enter the username and password used to log in the NVR. This username and password
should have the permission of disk management.
③ Check the disk you want to encrypt and then enter the password.
After you encrypt the data of a disk, this disk cannot be read by other NVRs unless it is
unlocked.
Data Decryption:
① Click "Change Encrypt".
② Enter the username and password used to log in the NVR. This user should have the
permission of disk management.
③ Check the disk you want to decrypt and then empty the password.
③
Click "Close Encrypt".
Unlock the disk: when one encrypted disk is transferred from another NVR to this NVR, it
will be in locked status. Then you can select this locked disk and click "Unlock". After you
enter the password of its data encryption, its status will be "Read Only". Now you can read the
data of this disk but it cannot be written too.
Some models may not support RAID function. The settings of RAID are as followings. Please
skip the settings of physical disk, array and disk mode if the NVR doesn't support this function.
RAID
Ø
① Enable RAID
(Go to StartàSettingsàDiskàDisk Mode)
66