Device Management; Network Configuration; Tcp/Ip Configuration - Vitek Transcendent VT-TNR Series User Manual

VITEK Industrial Video Products – Transcendent Series NVRs

13.1 Network Configuration

13.1.1 TCP/IP Configuration

Click StartàSettingsàNetworkàTCP/IP to go to the following interface. Check "Obtain an
IPv4 address automatically", "Obtain an IPv6 address automatically" and "Obtain DNS
automatically" to get the network addresses automatically, or manually enter the network
addresses. You can modify the MTU value according to the network condition (MTU, Maximum
Transmission Unit, can be modified according to network condition for higher network
transmission efficiency). Click "Apply" to save the settings.
Note:
Internal Ethernet Port
l
If you use the NVR with the PoE network ports, click "Internal Ethernet Port" to go to the
following interface.
The internal Ethernet port is the port which is used to connect all the PoE ports with the NVR
system. The PoE ports are available if the internal Ethernet port is online; if it is offline, all the
PoE ports will be unavailable, may be the internal Ethernet port is broken. The network addresses
of the internal Ethernet port can be changed to make the port in the same network segment with
the IP cameras which are directly connected to the PoE ports of the NVR (it is not recommended
to change the network addresses of the internal Ethernet port).
Mode: Non-long line mode or long line mode can be selectable. The non-line mode is the default
setting. If the transmission performance of your network cables connected the PoE ports and IPC
are not so good or these network cables are very long, you can choose long line mode.

13 Device Management

141