Web Wan Access - Vitek Transcendent VT-TNR Series User Manual

VITEK Industrial Video Products – Transcendent Series NVRs
Notes: 1. Please make sure that the IP address of the NVR and the computer are both in the same local
network segment. For example, supposing that the IP address of the computer is 192.168.1.41,
the IP address of the NVR should be set to 192.168.1.XXX.
2. If the HTTP port of the NVR is not 80, but other number instead, you need to enter the IP
address plus port number in the address bar when accessing the NVR over network. For example,
the HTTP port is 81. You should enter http://192.168.1.42:81 in the address bar.

14.3 Web WAN Access

NAT Access
Ø
① Set the network of the NVR. Please refer to 13.1.1 TCP/IP Configuration for details.
② Enable NAT and then set the NAT server address. Please refer to 13.1.8 NAT Configuration
for details.
③ Open a web browser on your computer, enter the NAT server address www.autonat.com or
NVT2.0 server address www.natplus.top in the address bar and then press enter to go to the
interface as shown below (download and install the relative plugin according to the tip if you
access the NVR through NAT for the first time).
160