Intrusion Detection - Vitek Transcendent VT-TNR Series User Manual

VITEK Industrial Video Products – Transcendent Series NVRs

9.4 Intrusion Detection

Intrusion Detection Configuration:
Alarms will be triggered if the people or vehicles intrude into the pre-defined area.
① Click StartàSettingsàAI/Event àAI EventàIntrusion to go to the following interface.
② Select the camera, enable the intrusion detection by IPC and set the duration.
Note: Some models may support tripwire detection by NVR.
③ Select regional activities. "Appear" or "Cross" can be selected (if your camera doesn't
support region entrance/exiting detection, "Cross" will not be enabled). If "Cross" is selected,
you can choose the crossing direction.
④ Select the alarm area. Up to 4 alarm areas can be set up.
⑤ Draw the alarm area of the intrusion detection. Refer to the interface as shown below. Check
"Draw Area" and then click around the area where you want to set as the alarm area in the image
(the alarm area should be a closed area). Uncheck the "Draw Area" if you finish the drawing.
Click the "Clear" to delete the alarm area.
⑥ Click "Detection Target" to choose the detection target and the sensitivity. The detection
target includes people, vehicle and non-vehicle.
⑦ Click "Trigger Mode" to configure intrusion detection alarm linkage items.
l Enable or disable "Record", "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up
Video" and "E-mail". The alarm linkage settings are the same as the face detection alarm (see
9.1.1 Face Detection Settings for details).
l Enable "IPC Audio" or "IPC Light" as needed. (only some IPCs support these two functions).
To set the IPC voice and its times and volume, please refer to 11.5.6 Audio for details. To set the
light flashing time and frequency of the IPC, please refer to 11.5.7 Light for details.
⑧ Click "Copy To" to copy all settings to other cameras.
98