Pppoe Configuration; Ddns Configuration - Vitek Transcendent VT-TNR Series User Manual

VITEK Industrial Video Products – Transcendent Series NVRs
stream; chID indicators channel ID).
Examples: ① Enable RTSP and "Anonymous". Then open the VLC player and enter the
address (for example: rtsp://192.168.1.88:554/chID=1&streamType=main) in the network
address bar of the VLC player. Then you can view the video of channel 1.
② Enable RTSP and open the VLC player. After that enter the address (for example:
rtsp://192.168.1.88:554/chID=1&streamType=sub) in the network address bar of the VLC
player. Then a login box will pop up. Enter the username and password which should be as the
same as the username and password of API server. Then you can view the video of channel 1.
Note: only some versions may support API server function. Please skip the following
instructions if your DVR does not support it.

13.1.3 PPPoE Configuration

Click StartàSettingsàNetworkàPPPoE to go to the interface as shown below. Check "Enable"
in "PPPoE Settings" and then enter the username and password obtained from the dealer. Click
"Apply" to save the settings.

13.1.4 DDNS Configuration

The DDNS is used to control the dynamic IP address through a domain name. You can access
the NVR easily if the DDNS is enabled and configured.
Click StartàSettingsàNetworkàDDNS to go to the interface as shown below.
Check "Enable" and then select the DDNS type. Enter the server address, domain name,
username and password according to the selected DDNS type. Click "Test" to test
146