Record & Disk Management; Record Configuration; Mode Configuration - Vitek Transcendent VT-TNR Series User Manual

VITEK Industrial Video Products – Transcendent Series NVRs
7 Record & Disk Management

7.1 Record Configuration

7.1.1 Mode Configuration

Please format the HDDs before recording (refer to 7.5 Disk Management for details). Click
StartàSettingsàRecordàMode Settings to go to the mode settings interface. You can set the
record time under the "Manual Record Settings" and then click "Apply" to save the settings.
There are two record modes: auto mode and manual mode.
Auto Mode
Ø
Motion Record: Motion alarm record will be enabled when motion is detected.
Sensor Record: Sensor alarm record will be enabled when sensor alarm trips.
Motion Record+Sensor Record: Motion/sensor alarm record will be enabled when
motion/sensor alarm occurs.
Always(24 7) Record+Motion Record: Normal record is enabled all the time; motion alarm
ⅹ
record will be started when motion is detected.
Always(24 7) Record+Sensor Record: Normal record is enabled all the time; sensor alarm
ⅹ
record will be started when sensor alarm trips.
Always(24 7) Record+Motion Record+Sensor Record: Normal record is enabled all the time;
ⅹ
motion/sensor alarm record will be enabled when motion/sensor alarm occurs.
Always(24 7) Record+ Motion Record + Sensor Record + AI Record: Normal record is
ⅹ
enabled all the time; AI record will be enabled when AI event happens.
You can add more auto modes on analytics record. Click "Advanced" to pop up a window as
shown below. Check the modes in the window and then click "Add" to show the modes in the
59