VITEK Industrial Video Products – Transcendent Series NVRs
11.5.7 Light
Click StartàSettingsàAlarmàEvent NotificationàLight to go to the interface as shown below.
In this interface, you can set the light flashing time and frequency when an alarm is triggered.
11.5.8 Alarm Server
Go to AlarmàAlarm Server interface as shown below.
Enable the alarm server and enter server address and port of the alarm server. Then select protocol.
If "Send Heartbeat" is enabled, set the interval times. After that, test the effectiveness of the
alarm server. Having tested successfully, please click "Apply". When an alarm occurs, the device
will transfer the alarm event to the alarm server. If an alarm server is not needed, there is no need
to configure this section.
11.6 Manual Alarm
Click
on the tool bar at the bottom of the live preview interface to pop up a window. Click
"Trigger" to start alarm. Click "Clear" to stop alarm.
11.7 View Alarm Status
Click StartàSettingsàAlarmàAlarm Status or click
on the tool bar at the bottom of the
132