Advanced Configuration; Encode Parameters Settings - Vitek Transcendent VT-TNR Series User Manual

VITEK Industrial Video Products – Transcendent Series NVRs
Click "All" to set all week recording; click "Reverse" to swap the selected and unselected time
in a week; click "Clear All" to clear all the selected area in a week.

7.1.3 Advanced Configuration

Click StartàSettingsàRecordàAdvanced to go to the following interface. Enable or disable
cycle record (cycle record: the earliest recorded data will be replaced by the newest when the
disks are full). Choose the record stream. Set the pre-alarm record time, post-alarm record time
and expiration time of each camera and then click "Apply" to save the settings.
Pre-alarm Record Time: set the time to record before the actual recording begins.
Post-alarm Record Time: set the time to record after the actual recording is finished.
Expiration Time: set the expiration time for recorded video. If the set date is overdue, the
recorded data will be deleted automatically.

7.2 Encode Parameters Settings

Click StartàSettingsàRecordàEncode Parameters to go to the interface as shown below. Set
the encode, resolution, FPS, GOP, bitrate type, quality, max bitrate and audio of main stream for
each camera in "Event Recording Settings" and "Schedule Recording Settings" interfaces. Click
"Apply" to save the settings. You can set the record stream of each camera one by one or set
them in bulk for all cameras.
64