VITEK Industrial Video Products – Transcendent Series NVRs
Crowd Density Configuration:
Alarms will be triggered if the crowd density exceeds the set threshold value in the pre-defined
area.
① Click StartàSettingsàAI/EventàAI EventàCrowd Density to go to the following interface.
② Select the camera, enable the crowd density detection and set the duration, refresh frequency
and alarm threshold.
Refresh Frequency: It refers to the refresh time of the detection result report.
Alarm Threshold: Alarms will be triggered once the percentage of the crowd density in a
specified area exceeds the pre-defined threshold value.
Select the alarm area. Draw the alarm area of the crowd density detection. Refer to the
④
interface as shown below. Check "Draw Area" and then drag the mouse to draw a rectangle
area. Uncheck the "Draw Area" when you finish drawing. Click the "Clear" to delete the
detection area.
⑤ Click
to configure crowd density detection alarm linkage items. Enable or disable
"Record", "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video" and "E-mail".
The alarm linkage settings are the same as the face detection alarm (see 9.1.1 Face Detection
Settings for details).
⑥ Click "Apply" to save the settings.
9.7 Line Crossing Counting
Only some IPCs may support this function.
People counting in the pre-defined area:
l
This function is to calculate the number of people entering or exiting in the detected area on the
100