Pos Settings - Vitek Transcendent VT-TNR Series User Manual

VITEK Industrial Video Products – Transcendent Series NVRs
Start Sequence View
Ø
Go to live preview interface and then click
window and then click
interface to pause the view; double click again to restore the view. Click
Note:
You can set the secondary output preview if the NVR has dual outputs. Refer to the interface as
shown below.
Check "Dwell" and then set scheme view in sequence of the secondary output. The setting steps
are similar to that of the main output.
Set quick sequence view if "Dwell" is not checked. The setting steps are as follows:
① Set screen mode by clicking the relevant buttons on the tool bar.
② Select one window and then double click one camera or group in the list.
③ Click "Apply" to save the settings after adding cameras or groups to the windows.

5.3 POS Settings

This function is only available for some models. If your NVR doesn't support such function,
please skip the following instructions.
① Click StartàSettingsàBasicàPOS Settings to go to the interface.
② Enable POS and click "Configure" under "Connection Settings" to go to the following
interface.
③ Enter IP address of the POS you want to add.
④ Check "POS port" and then enter POS port.
to start scheme view in sequence. Double click the sequence view
41
to pop up a window. Set the dwell time in the
to stop the view.