Upnp Configuration; 150 - Vitek Transcendent VT-TNR Series User Manual

VITEK Industrial Video Products – Transcendent Series NVRs

13.1.6 UPnP Configuration

By UPnP you can access the NVR through web client which is in WAN via router without port
mapping.
① Click StartàSettingsàNetworkàUPnP to go to the following interface.
② Make sure the router supports UPnP function and the UPnP is enabled in the router.
③ Set the NVR's IP address, subnet mask and gateway and so on corresponding to the router.
④ Check "Enable" in the interface as shown below and then click "Apply".
Click the "Refresh" button to refresh the UPnP status. If the UPnP status is "Invalid UPnP" after
refreshing it a few times, the port number may be wrong. Please change the mapping type to
"Manual" and then click
Refer to the following picture. You can view the external IP address of the NVR. Enter the
external IP address plus port in the address bar to access the NVR such as http://123.45.678.91:81.
13.1.7 802.1X
If it is enabled, the NVR data can be protected. When the NVR is connected to the network
protected by the IEEE 802.1X, user authentication is needed.
To use this function, the NVR should be connected to a switch supporting 802.1x protocol. The
switch can be considered as an authentication system to identify the device in a local network. If
the NVR connected to the network interface of the switch has passed the authentication of the
switch, it can be accessed via the local network.
to modify the port until the UPnP status turns to "Valid UPnP".

150