Basic Operation Guide; Startup & Shutdown; Startup; Shutdown - Vitek Transcendent VT-TNR Series User Manual

VITEK Industrial Video Products – Transcendent Series NVRs
2.1 Startup & Shutdown
Please make sure all the connections are done properly before you apply power to the unit. Proper
startup and shutdown are crucial to extending the life of your device.

2.1.1 Startup

① Connect the output display device to the VGA/HDMI interface of the NVR.
② Connect the mouse and power. The device will boot-up and the power LED will turn blue.
③ After you read the privacy statement, a WIZARD window will pop up (you should select
the display language the first time you use the NVR). Refer to 3.1 Startup Wizard for details.

2.1.2 Shutdown

You can power off the device by using remote controller or mouse.
By remote controller:
① Press the Power button. This will take you to a shutdown window. The unit will power off
after clicking the "OK" button.
② Disconnect the power.
By mouse:
① Click StartàShutdown to pop up the Shutdown window. Select "Shutdown" in the window.
The unit will power off after clicking the "OK" button.
② Disconnect the power.

2.2 Remote Controller

① Uses two AAA size batteries.
② Open the battery cover of the remote controller.
③ Place batteries. Please observe the polarity (+ and -).
④ Replace the battery cover.
Key points to check in case the remote doesn't work.
1. Check batteries polarity.
2. Check the remaining charge in the batteries.
3. Check IR controller sensor for any masking.
If it still doesn't work, please change to a new remote controller, or contact your dealer. You can
turn the IR sensor of the remote controller toward the IR receiver of the NVR to control it when
you are controlling multiple devices by remote controller.
There are two kinds of remote controller. The interface of remote controller is shown as below.

2 Basic Operation Guide

12