Face Database Management - Vitek Transcendent VT-TNR Series User Manual

VITEK Industrial Video Products – Transcendent Series NVRs
Face Detection Alarm Linkage Configuration:
Trigger "Record", "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video"
l
and "E-mail" as needed.
Record: Click the "Configure" button to pop up the window. Select camera on the left side and
then click
and then click
cameras will record automatically when faces are detected.
Alarm-out: Click the "Configure" button to pop up the window. Then the "Trigger Alarm-out"
window will pop up automatically. Configure the trigger alarm-out in the window. The system
will trigger the alarm-out automatically when faces are detected. You need to set the delay time
and the schedule of the alarm outputs. See 11.5.1 Alarm-out for details.
Preset: Click
Preset Setting for details.
Snapshot: check it. The current camera will capture images automatically when faces are
detected.
Push: If it is enabled, the system will send messages when faces are detected.
Buzzer: if it is enabled, the system will begin to buzz when faces are detected. To set the delay
time of the buzzer, please see 11.5.4 Buzzer for details.
Pop-up Video: if it is enabled, the system will pop up the corresponding video automatically
when faces are detected. To set the duration time of the video, please see 11.5.3 Display for
details.
E-mail: if it is enabled, the system will send an e-mail when faces are detected. Before you
enable the email, please configure the recipient's e-mail address first (see 13.1.5 E-mail
Configuration for details).
⑨ Click "Apply" to save the settings.

9.1.2 Face Database Management

① Click StartàSettingsàAI/EventàAI EventàFace RecognitionàFace Database to go to
the following interface as shown below.
to set the camera as the trigger camera. Select trigger camera on the right side
to cancel the trigger camera. Click "OK" to save the settings. The trigger
and then select the preset for each camera. To add presets, please see 6.2
88