Table of Contents
Advertisement
settings remain stored on the module. If
you wish to change the module, you have to
remove it first. The module does not need
to be deactivated to do this. Deactivation is
only useful if you do not intend to use the
module again with COMAND Online.
Telephone module with Bluetooth
(SAP profile) in SIM card mode
Inserting a SIM card
With the contact surface facing down,
X
insert SIM card : into the SIM card slot
until it engages.
After a SIM card is inserted in the module, a
®
Bluetooth
connection with another
mobile phone is no longer possible. Any
®
existing Bluetooth
upon SIM card insertion.
Removing a SIM card
Press the SIM card and then release it.
X
The SIM card is pushed out slightly and can
then be removed.
Connect the mobile phone
General notes
When you use your mobile phone with the
module and COMAND Online for the first
time, you must search for and authorise it.
If your mobile phone has already been author-
ised, it will be connected automatically.
COMAND Online always searches for the last
connected mobile phone. If no connection
can be made to the most recently connected
®
connection is ended
mobile phone, the system searches for the
mobile phone that was connected before that
one.
You can authorise up to 15 mobile phones.
Only one mobile phone can be connected to
the module and COMAND Online at any one
time.
You can configure the mobile phone PIN to be
stored in the module (
establishing a Bluetooth
entering the PIN is only necessary if the SIM
card PIN has been changed.
Conditions
You can authorise and connect your mobile
phone to the module, if:
the module is installed (
R
activated in COMAND Online
(
page 420)
Y
no SIM card is inserted in the module
R
the mobile phone has no active Bluetooth
R
connection to another device
the mobile phone supports the Bluetooth
R
SAP profile (SIM Access Profile)
Depending on the type of mobile phone, dif-
ferent settings must be changed on the
mobile phone (see the operating instructions
for the mobile phone).
®
Bluetooth
must be activated on the
R
mobile phone and must be made visible to
other devices.
®
The Bluetooth
SIM Access Profile of the
R
mobile phone must be activated.
You must know the Bluetooth
R
mobile phone.
A list of mobile phones which are compatible
with the telephone module with Bluetooth
(SAP profile) can be found on the Internet at:
http://www.mercedes-benz.com/connect
Telephone
page 423). When
Y
®
connection, re-
page 420) and
Y
®
name of the
®
Z
421
®
®
Advertisement
Table of Contents
