Table of Contents
Advertisement
Navigation
376
Geo-coordinate display
Current height above average sea level
:
(rounded to the nearest 10 m)
Current vehicle position: latitude coordi-
;
nates
Current vehicle position: longitude coor-
=
dinates
Number of GPS satellites currently being
?
used
There must be sufficient GPS reception for all
displays to be shown. If this is not the case,
the display will be greyed out. Height dis-
play : may vary from the actual value,
because the navigation system uses the GPS
signals for the calculation.
During the "Move map" function, you will see
the geo-coordinates of the crosshair position.
Height display : and number of satellites
used ? are not displayed.
Display switched off
Current map orientation
:
While moving the map, you will see additional
data depending on the crosshair position if
the digital map supports this data. A street
name, for example, can be shown here
(
page 373).
Y
Compass view on the map
To show the menu: press W the COMAND
X
controller.
Select
Navi
Navi
in the main function bar by
X
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select
Map
Map settings
settings
X
firm.
The map settings menu appears.
Select
Compass on map
Compass on map
X
confirm.
A menu appears.
Select
Never,
Never
When off-road
When off-road
X
route guidance inactive
route guidance inactive
to confirm.
The selected setting is accepted.
Switching additional information on/off
Example: topographic map
Switching the topographic map on/off
To show the menu: press W the COMAND
X
controller.
and press W to con-
and press W to
or
When
When
and press W
Advertisement
Table of Contents
