Table of Contents
Advertisement
Audio
472
i
Not all memory cards available on the
market are designed for the temperatures
which may be reached in the vehicle.
If the SD memory card is no longer in use,
you should remove it from
COMAND Online. High temperatures can
damage the card.
Due to the wide range of SD memory cards
available on the market, playback cannot
be guaranteed for all brands of SD memory
card.
The readable storage capacity depends on
the memory card used. You can obtain fur-
ther information at any Mercedes-Benz
Service Centre.
Inserting an SD memory card
Insert the memory card into the slot on the
X
control panel until it engages in place. The
side with the contacts must face down-
wards and point towards the slot.
If no MP3 tracks can be found, you will see
a message to this effect.
The first 100 MP3 tracks are loaded. The
first MP3 track is then played. An hourglass
symbol indicates that further tracks are
being loaded in the background.
Ejecting an SD memory card
Press the memory card.
X
The memory card is ejected.
Remove the memory card from the slot.
X
Connecting a USB device
The USB port is located in the stowage com-
partment in the centre console.
Electrical consumption at this connection
must not exceed a continuous current of
500 mA. If the electrical consumption is
higher, use a separate source to provide
power for the USB device (e.g.
12 V power supply).
Connect the USB device (e.g. USB stick) to
X
the USB port.
If no MP3 tracks can be found, you will see
a message to this effect.
The first 100 MP3 tracks are loaded. The
first MP3 track is then played. An hourglass
symbol indicates that further tracks are
being loaded in the background.
i
Due to the wide range of USB devices
available on the market, playback cannot
be guaranteed for all brands of USB device.
Information about suitable USB devices
can be obtained from a Mercedes-Benz
Service Centre.
MP3 players must support Media Transfer
Protocol (MTP). The MTP mode must be
active.
Switching to audio CD/audio DVD or
MP3 mode
Inserting or connecting a data medium
Insert CDs/DVDs (
X
or
Inserting an SD memory card
X
(
page 472)
Y
or
Connect a USB device (
X
COMAND loads the medium inserted and
starts to play it.
Switching on using the button
Press the h function button one or more
X
times.
By pressing the function button repeatedly,
you can change the operating mode in the
following order:
audio CD/DVD/video DVD/MP3 CD/MP3
R
DVD in the DVD changer or single DVD
drive (disc mode)
memory card mode
R
MUSIC REGISTER
R
USB memory
R
Media Interface or audio AUX mode
R
operation with Bluetooth
R
Select an audio medium from the media list
X
(
page 474).
Y
page 469)
Y
page 472).
Y
®
audio
Advertisement
Table of Contents
