Table of Contents
Advertisement
Roof
108
Draught stop
=
Pin
?
Front brackets for draught stop
A
Lock cover (example: front-passenger
B
side)
Make sure that draught stop = is folded
X
back.
Push the upper half of cover B on draught
X
stop =.
Repeat the procedure with the cover on the
X
driver's side.
Draught stop = is unlocked.
Hold draught stop = at an angle and insert
X
pins ? into the rear brackets.
Make sure that pins ? sit correctly in the
brackets.
Insert draught stop = into front brackets
X
A.
Check whether draught stop = is correctly
X
seated in all four brackets.
Push the lower half of cover B on draught
X
stop =.
Draught stop = is locked.
Fold draught stop = forward if necessary.
X
To remove: make sure that draught stop
X
= is folded back.
Push the upper half of cover B on draught
X
stop =.
Draught stop = is unlocked.
First remove draught stop = from front
X
brackets A.
Hold draught stop = at an angle and then
X
remove from the rear brackets.
Slide covers : and ; of the rear brackets
X
against the direction of the arrow until they
are fully closed.
Electrical draught stop
Important safety notes
WARNING
G
If you use the draught stop in darkness or in
other conditions offering poor visibility, your
view to the rear is further impaired. There is a
risk of an accident.
Only use the draught stop when visibility con-
ditions are good.
! When extending or retracting the draught
stop, make sure there are no objects on the
rear compartment trim. Otherwise, the
objects could damage the draught stop.
The draught stop offers protection from the
wind when driving with the roof down. The
roof must be fully open before the draught
stop can be extended.
Extending and retracting
Open the roof (
page 103).
X
Y
Open the cover on the lower centre con-
X
sole.
The switch for the electrical draught stop is
under the cover.
To extend: press button :.
X
To retract: press button : again.
X
Advertisement
Table of Contents
