Table of Contents
Advertisement
Roof
106
not place any objects on the cover
R
behind the roll bars
not allow the load to push up the boot
R
separator
! Make sure that the boot separator is fully
closed. Otherwise, the roof could be
blocked when opening or closing.
The boot separator can be used to cover lug-
gage and loads in the boot.
Opening and closing
Closed boot separator
Boot separator
:
Eyelets
;
Handle
=
To close: pull boot separator : in the
X
direction of the arrow by handle =.
Hook boot separator : into fastening eye-
X
lets ; in the side panels.
To open: remove boot separator : from
X
fastening eyelets ; in the side panels.
Push boot separator : against the direc-
X
tion of the arrow by handle =.
Removing and fitting
Closed boot separator
Boot separator
:
Net
;
Eyelets
=
Handle
?
To remove: unhook net ; from the holder
X
on the left and right-hand sides and guide it
to the rear until it is completely rolled up.
Remove boot separator : from fastening
X
eyelets = in the side panels.
Push boot separator : against the direc-
X
tion of the arrow by handle ?.
Opened boot separator
Boot separator
:
Catch lever (example: driver's side)
A
Turn driver's side catch lever A in the
X
direction of the arrow.
Repeat the same process on the catch lever
X
on the passenger side.
Boot separator : is unlocked.
Pull out boot separator : in the direction
X
of the arrow.
Advertisement
Table of Contents
