Tcp/Ip Parameter Configuration - Agilent Technologies InfinityLab LC Series User Manual

12 LAN Configuration

TCP/IP Parameter Configuration

TCP/IP Parameter Configuration

To operate properly in a network environment, the LAN interface must be
configured with valid TCP/IP network parameters. These parameters are:
•
•
•
The TCP/IP parameters can be configured by the following methods:
•
•
•
The LAN interface differentiates between several initialization modes. The
initialization mode (short form 'init mode') defines how to determine the active
TCP/IP parameters after power-on. The parameters may be derived from
non-volatile memory or initialized with known default values. The initialization
mode is selected by the configuration switch, see
1260 Infinity II Flexible Pump User Manual
IP address
Subnet Mask
Default Gateway
by automatically requesting the parameters from a network-based DHCP
Server (using the so-called Dynamic Host Configuration Protocol). This mode
requires a LAN-onboard Module or a G1369C LAN Interface card, see
(DHCP)" on page 288
by manually setting the parameters using Telnet
by manually setting the parameters using the Instant Pilot (G4208A)
Table 24 on page 285.
"Setup
283