2D Reread Delay; Character Activation Mode - Honeywell Xenon 1910 User Manual

2D Reread Delay

Sometimes 2D bar codes can take longer to read than other bar codes. If you wish to set a separate Reread Delay for 2D
bar codes, scan one of the programming codes that follows. 2D Reread Delay Off indicates that the time set for
Delay is used for both 1D and 2D bar codes. Default = 2D Reread Delay Off.
* 2D Reread Delay Off
Medium (2000ms)
Extra Long (4000ms)

Character Activation Mode

You may use a character sent from the host to trigger the scanner to begin scanning. When the activation character is received,
the scanner continues scanning until either the
(see Deactivation Character
vation, then use Activation Character (following) to select the character you will send from the host to start scanning. Default =
Off.
* Off
Character Activation Timeout
on page 4-15), or a bar code is transmitted. Scan the following On bar code to use character acti-
Short (1000ms)
Long (3000ms)
(page 4-14), the deactivation character is received
Reread
On
4 - 13