Object Detection Distance
When the scanner is in the stand and you are using Object Detection
Mode, you can set the distance range for detecting objects. Short sets the
scanner to detect objects approximately 5 inches (12.7cm) away from the
nose. Long sets it to detect objects approximately 10 inches (25.4cm)
away. Default = Short In-Stand, Long Out-of-Stand.
* Short
In-Stand
Out-of-Stand
Character Activation Mode
You may use a character sent from the host to trigger the scanner to begin
scanning. When the activation character is received, the scanner continues
scanning until either the
deactivation character is received (see
or a bar code is transmitted. Scan the On bar code below to use character acti-
vation, then use Activation Character (following) to select the character you will
send from the host to start scanning. Default = Off.
* Off
Activation Character
This sets the character used to trigger scanning when using Character Acti-
vation Mode. On the
A-3, find the hex value that represents the character you want to use to trig-
ger scanning. Scan the bar code below, then use the
Short
Character Activation Laser Timeout
ASCII Conversion Chart (Code Page 1252)
Deactivation Character
Long
In-Stand
* Long
Out-of-Stand
(page 3-14), the
on page 3-15),
On
on page
Programming Chart
3 - 13