Output Torque Detection Function - Mitsubishi Electric 800 Series Instruction Manual

11.9

Output torque detection function

Magnetic flux Sensorless Sensorless Sensorless
Magnetic flux Magnetic flux
If the motor torque which reaches a specific value is detected, the relative signal is output.
The signal is useful for applying or releasing electromagnetic brake, etc.
Pr.
864
Torque detection
M470
• The Torque detection (TU) signal turns ON when the motor output torque reaches the value of torque set in Pr.864 or
higher. The TU signal turns OFF when the motor output torque drops lower than the set value.
• Pr.864 is not available under V/F control.
• To use the TU signal, set "35" (positive logic) or "135" (negative logic) in one of Pr.190 to Pr.196 (Output terminal
function selection) to assign the function to the output terminal.
TU
NOTE
• Changing the terminal assignment using Pr.190 to Pr.196 (Output terminal function selection) may affect the other
functions. Set parameters after confirming the function of each terminal.
Parameters referred to
Pr.190 to Pr.196 (Output terminal function
270
11.(M) Item and Output Signal for Monitoring
11.9 Output torque detection function
PM PM PM
Name
150%
Pr.864
ON
selection)page 258
Initial value Setting range
0% to 400%
Time
OFF
Description
Set a value of the torque at which the TU
signal turns ON.