Mitsubishi Electric 800 Series Instruction Manual page 20

No. Appearance Name
(j) MODE key
(k) SET key
(l) RUN key
(m) STOP/RESET key
(n) USB connector
*1 Situations such as when the MRS/X10 signal is input, during the automatic restart after instantaneous power failure, after auto tuning is complete,
when "SE" (incorrect parameter setting) alarm occurs.
Switches the operation panel to a different mode.
The easy setting of the inverter operation mode is enabled by pressing this key simultaneously
with the PU/EXT key.
Every key on the operation panel becomes inoperable by holding this key for 2 seconds. The
key inoperable function is invalid when Pr.161 = "0 (initial setting)". (Refer to
Confirms each selection.
When this key is pressed during inverter operation,
the monitor item changes.
(The monitor item on each screen can be changed
according to the settings of Pr.52, Pr.774 to Pr.776.)
Start command
The direction of motor rotation depends on the Pr.40 setting.
Stops the operation commands.
Used to reset the inverter when the protective function is activated.
FR Configurator2 is available by USB connection.
Description
Initial setting in the monitor mode
Output Output
frequency current
2.1 Operation panel
1
page 136.)
2
Output
voltage
3
4
5
6
7
8
9
10
19
2. Basic Operation