Mitsubishi Electric 800 Series Instruction Manual page 13

• E: The output specification for monitoring and the rated frequency are shown for the standard model, and the
communication protocol group is shown for the Ethernet model and the safety communication model.
Symbol
-1 Pulse (terminal FM)
-4 Voltage (terminal AM)
-5 Voltage (terminal AM)
Protocol group A (CC-Link IE TSN, CC-Link IE Field Network Basic, MODBUS/
PA
TCP, EtherNet/IP, and BACnet/IP)
Protocol group B (CC-Link IE TSN, CC-Link IE Field Network Basic, MODBUS/
PB
TCP, PROFINET)
• F: Availability of circuit board coating / plated conductors is shown.
Symbol
None Without coating
-60 With coating
*1 Conforming to IEC 60721-3-3 3C2
NOTE
• In this Instruction Manual, the inverter model name consists of the applicable motor capacity and the rated current.
(Example) FR-E820-0008(0.1K)
 How to read the SERIAL number
Rating plate example
Symbol Year Month Control number
SERIAL
12
1. Introduction
1.1 Inverter model
Monitoring/protocol specification
*1
Circuit board coating
The SERIAL consists of two symbols, three characters indicating the production year
and month, and six characters indicating the control number.
The last two digits of the production year are indicated as the Year, and the Month is
indicated by 1 to 9, X (October), Y (November), or Z (December).
Plated conductor
Without plated conductors
Without plated conductors
Rated frequency Control logic
60 Hz Sink logic
50 Hz Source logic
60 Hz Sink logic
60 Hz Sink logic
50 Hz Source logic