Removing The Upper Air Grille And Vertical Brackets; Prerequisites; Required Tools And Equipment; Steps - Cisco SRS Series Installation Manual

Installing and Removing Exterior Cosmetic Components

Removing the Upper Air Grille and Vertical Brackets

This section describes how to remove the upper air grille and vertical brackets from the rear (MSC) side of
the LCC,

Prerequisites

Before performing these tasks, ensure that the LCC power is off.

Required Tools and Equipment

You need the following tool to perform this task:
• 6-inch large Phillips screwdriver

Steps

To remove the upper air grille and vertical brackets from the rear (MSC) side of the chassis, perform the
following steps:
SUMMARY STEPS
1. Remove the upper air grille by unsnapping the bottom portion from the ball stud snaps on the vertical
mounting brackets.
2. Rotate the grille toward you on its hook hanger brackets, and then lift it clear of the brackets.
3. Set it carefully aside.
4. Using the large Phillips screwdriver, loosen the three panel fasteners on the two short vertical brackets
installed on the rear of the chassis.
5. Remove the vertical brackets and carefully set them aside.
DETAILED STEPS
Step 1 Remove the upper air grille by unsnapping the bottom portion from the ball stud snaps on the vertical mounting brackets.
Step 2
Rotate the grille toward you on its hook hanger brackets, and then lift it clear of the brackets.
Step 3 Set it carefully aside.
Step 4
Using the large Phillips screwdriver, loosen the three panel fasteners on the two short vertical brackets installed on the
rear of the chassis.
Step 5 Remove the vertical brackets and carefully set them aside.

Removing the Rear Kick Panel

This section describes how to remove the rear kick panel from the rear side of the LCC.
Prerequisites
There are no prerequisites for removing the rear kick panel.
Removing the Upper Air Grille and Vertical Brackets
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
207