Prerequisites; Required Tools And Equipment; Steps - Cisco SRS Series Installation Manual

Installing and Removing Power Components
Figure 25: LCC Front (PLIM) Side Slot Numbers

Prerequisites

Before performing this task, you must install and wire the power shelves, and install the power modules (AC
rectifiers or DC PEMS), and alarm modules. See
AC Rectifier or DC

Required Tools and Equipment

You need the following tools to perform this task:
• ESD-preventive wrist strap
• Multimeter
• 1/4-in. x 6-in. long slotted screwdriver

Steps

To power on the chassis, perform the following steps:
PEM, and Installing a Fixed Configuration Alarm
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
Installing a Fixed Configuration Power
Module.
Prerequisites
Shelf, Installing an
49