Removing The Currently Installed Inlet Grille Frame Assembly - Cisco SRS Series Installation Manual

Upgrading Chassis Components
Step 2
Rotate the grille toward you on its hook hanger brackets, then lift it clear of the support, and set it carefully aside for later
use.

Removing the Currently Installed Inlet Grille Frame Assembly

Now that the inlet grille has been removed, you must remove the lower grille frame assembly.
Prerequisites
Before performing this task, ensure that the lower grille has been removed from the front (PLIM) side of the
chassis. See
Steps
To remove the currently installed lower grille frame assembly, perform the following steps:
SUMMARY STEPS
1. Use the Phillips screwdriver to unscrew the four captive screws, two on each side, that attach the inlet
grille frame assembly to the chassis (see figure).
2. Rotate the assembly forward, lift it away from the chassis, and set it aside.
DETAILED STEPS
Step 1
Use the Phillips screwdriver to unscrew the four captive screws, two on each side, that attach the inlet grille frame assembly
to the chassis (see figure).
Removing the Currently Attached Upper Rear Grille, on page 222
Removing the Currently Installed Inlet Grille Frame Assembly
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
for more information.
219