Cisco SRS Series Installation Manual page 207

Installing and Removing Exterior Cosmetic Components
Figure 103: Removing the Front Logo Bezel and Upper Grille
Removing the Front Vertical Cable Troughs
Step 8 Remove the vertical cable troughs (see the next figure)—one right and one left—from the front (PLIM) side of the
chassis:
a) Use the screwdriver to turn the 12 flat head screws (six on each side) counterclockwise, remove them from the
cable troughs, and set them aside.
b) Slide the cable troughs upward slightly to unhook them from the guide slots; lift them away from the chassis, and
set them aside.
Note We recommend that you use two people to remove the troughs, one person to hold the troughs while the
other person removes the screws.
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
Steps
187