About Cable Management Brackets - Cisco SRS Series Installation Manual

About Cable Management Brackets

Note Only the original route processor (RP) card uses a PCMCIA card. The performance route processor (PRP)
card has a USB connector for using a flash drive.
Note Core dumps are discoverable only through intervention with the LCC system software.
Physically, the RP or DRP hard drive is a hot-pluggable PC board and sled-mounted drive with a connector
interface that gets cleanly seated into a route processor card. In general, removal and replacement of this drive
is not required.
The RP and DRP cards provide two PCMCIA flash slots, each card providing up to 1 GB of flash storage.
One PCMCIA flash subsystem is accessible externally, is removable, and allows you to transfer images and
configurations by plugging in a PCMCIA flash card. The other subsystem is fixed to the RP or DRP, not
removable, and for permanent storage of configurations and images.
About Cable Management Brackets
The chassis includes a cable management system that organizes the interface cables entering and exiting the
different cards, keeping them out of the way and free of sharp bends.
Caution
Excessive bending of interface cables can cause damage to the cables.
The LCC arrives with a midchassis and upper-chassis horizontal cable management bracket preinstalled on
the front (PLIM) side of the chassis, with an optional upper-chassis horizontal cable management bracket
available for the rear (MSC) side of the chassis.
The following figure shows the midchassis cable management bracket.
Figure 60: Midchassis Cable Management Bracket (Front [PLIM] Side of Chassis Only)
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
112
Installing and Removing Line Cards, PLIMs, and Associated Components