Installing The Optional Rear (Msc) Side Cosmetic Components - Cisco SRS Series Installation Manual

Installing the Optional Rear (MSC) Side Cosmetic Components

Figure 109: Attaching the Rear Kick Panel
1 Hook hanger brackets
Step 6
To secure the top fasteners, firmly press the top edge of the rear kick panel against the top of the rear kick panel bracket
until it snaps onto the ball stud retainers.
Installing the Optional Rear (MSC) Side Cosmetic Components
This section describes how to install the optional rear (MSC) side exterior cosmetic components, shown in
Figure 94: Rear (MSC) Side Exterior Cosmetic Components—Optional Multi Chassis
While it is possible to install the various exterior components on the chassis in a different order, it is easier
to install them in the order outlined in this section.
This section contains the following procedures:
• Attaching the Rear Vertical Cable Troughs
• Attaching the Rear Door Strike Tube
• Attaching the Mid-chassis Horizontal Cable Management Bracket
• Attaching the Door Stop
• Installing the Rear Doors
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
194
2 Ball studs
Installing and Removing Exterior Cosmetic Components
System, on the LCC.