Installing An Rp, Prp, Or Drp Card - Cisco SRS Series Installation Manual

Installing and Removing Line Cards, PLIMs, and Associated Components

Installing an RP, PRP, or DRP Card

Figure 80: Distributed Route Processor Card
DRPs contain two CPU complexes, independent of each other, each with its own hard drive. In addition, the
DRP provides you with two PCMCIA card slots, similar to the RP. For further information, see About Hard
Drives and PCMCIA Cards, on page 111. For installation or removal information, see Installing or Removing
a Card-Based Hard Drive, on page 161 or Installing or Removing a PCMCIA Card, on page 163.
Installing an RP, PRP, or DRP Card
This section describes how to install a route processor (RP), performance route processor (PRP), or a DRP
card in the LCC. Every LCC contains two RP or PRP cards in dedicated slots on the PLIM side of the chassis
(see the following figure).
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
146