Removing A Pillow Block; Prerequisites; Required Tools And Equipment - Cisco SRS Series Installation Manual

Removing a Pillow Block

Figure 63: Installing a Pillow Block
Step 6
Install the lower right screw (see item number 3 in the above figure).
Step 7 Install the lower left screw (located below the pillow block pin). (See item number 4 in the above figure).
Step 8
Repeat this procedure for the card slot's other pillow block if necessary.
What to do next
After performing this task, close the front cosmetic doors (if installed).
Removing a Pillow Block
This section describes how to remove a damaged pillow block from the chassis. A pillow block is a bracket
with a pin that is attached to the chassis above and below each card slot. When you install or remove a card
from the chassis, the card ejector levers hook into the pillow blocks above and below the card slot to secure
the cards to the slot and allow you to install and remove the cards.

Prerequisites

Before performing this task, you must first open the front cosmetic doors (if installed). Have the pillow block
replacement kit (Cisco product number: CRS-PILLBLK=) at hand.

Required Tools and Equipment

You need the following tools and parts to perform this task:
• ESD-preventive wrist strap
• 1 T10 Torx screwdriver (part of the Pillow block replacement kit—Cisco product number:
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
120
CRS-PILLBLK=)
Installing and Removing Line Cards, PLIMs, and Associated Components