Cisco SRS Series Installation Manual page 201

Installing and Removing Exterior Cosmetic Components
Figure 99: Inlet Grille Screen and Frame Assembly
Step 12 Attach the frame assembly to the chassis as in the previous figure by aligning the four screws, two on each side, on the
frame to the screw holes on the chassis and tightening them with the screwdriver.
Step 13 Reattach the inlet grille screen (see the previous figure) to the frame assembly by aligning the four captive screws on
the screen to the screw holes on the frame assembly and tightening the screws with the screwdriver.
Attaching the Lower Grille
Step 14 Attach the lower grille by carefully inserting the tabs on the grille into the hook hanger brackets on the inlet grille frame.
Step 15
Press the lower grille firmly until it snaps onto the ball stud snaps.
Attaching the Front Exterior Doors
Step 16 Orient the doors so that the keyholes slots are pointing up (see the next figure).
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
Steps
181