Cisco SRS Series Installation Manual page 148

Steps
Figure 67: Removing a Switch Fabric Card
1 Captive screw
2 Ejector lever
SUMMARY STEPS
1. Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection
sockets on the front (PLIM) side of the chassis or a bare metal surface on the chassis.
2. Identify the switch fabric card to be removed from the card cage. Use the screwdriver to turn the two
captive screws on the front panel of the card counterclockwise to loosen it from the slot.
3. Grasp the two card ejector levers and simultaneously pivot both ejector levers 90 degrees (70 degrees for
a newer switch fabric card) away from the front edge of the card carrier to unseat the card from the
midplane connector.
4. Touching only the metal card carrier, slide the card from the slot and place it directly into an antistatic
sack or other ESD-preventive container. If you plan to return the defective card to the factory, repackage
it in its original shipping container.
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
128
3 Direction of installation or removal
Installing and Removing Line Cards, PLIMs, and Associated Components