Steps; Removing The Optional Rear (Msc) Side Cosmetic Components - Cisco SRS Series Installation Manual

Steps

Steps
To remove the rear kick panel from the LCC, follow these steps:
SUMMARY STEPS
1. Remove the rear kick panel by unsnapping the top portion from the ball stud retainers on the rear kick
panel bracket.
2. Rotate the grille toward you on its hook hanger brackets, and then lift it clear of the tabs at the bottom of
the rear kick panel bracket, and set it carefully aside.
DETAILED STEPS
Step 1
Remove the rear kick panel by unsnapping the top portion from the ball stud retainers on the rear kick panel bracket.
Figure 119: Removing the Rear Kick Panel
1 Hook hanger brackets
Step 2 Rotate the grille toward you on its hook hanger brackets, and then lift it clear of the tabs at the bottom of the rear kick
panel bracket, and set it carefully aside.

Removing the Optional Rear (MSC) Side Cosmetic Components

This section describes how to remove the rear (MSC) side exterior cosmetic components, shown in
94: Rear (MSC) Side Exterior Cosmetic Components—Optional Multi Chassis
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
208
2 Ball studs
Installing and Removing Exterior Cosmetic Components
System, from the chassis. This
Figure