Cisco SRS Series Installation Manual page 100

Steps
Figure 44: Removing the Terminal Block Cover
1 DC terminal block.
2 Screw to tighten (pre-installed on terminal block)
3 Screwdriver securing the cover
4 Terminal block cover
Step 3
Remove the terminal block cover.
Step 4 Using the 10-mm socket wrench, remove the positive and negative cable pairs from each terminal block.
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
80
Installing and Removing Power Components
5 Opening to align over mounting pins
6 Opening to align over mounting pins
7 Cover latch tab