Removing An Lcc Fan Controller Card; Prerequisites; Required Tools And Equipment - Cisco SRS Series Installation Manual

Cisco crs routers 16-slot line card chassis

Table of Contents

Installing and Removing Line Cards, PLIMs, and Associated Components

For easier installation, install the far left card first.

Note

Step 4

Slide the card halfway into the slot. Avoid touching the card circuitry or any connectors.

Note

Alignment grooves exist on each slot in the card cage. When you install a card in the card cage, make sure that

you align both edges of the card carrier in the slot grooves.

Step 5

Pivot both card ejector levers so that the openings on the card ejector cams at the top and bottom of the card pass over

the tabs on each side of the card cage slot.

Caution

Verify that the openings on the card ejector cams pass over the tabs; otherwise, one or both ejector levers might

bind when you attempt to close the levers, thereby damaging or breaking one or both of them.

Step 6

Continue sliding the card into the card cage slot until the openings on the card ejector cams engage the tabs on each side

of the slot.

Note

The LCC fan controller card has guide pins that make initial contact with the midplane connector as you slide

a card into its slot. After the guide pins make contact, continue pushing the card carrier until the card ejector

levers begin pivoting forward, toward the handle in the card carrier.

Step 7

To seat the card in the midplane connector, grasp both card ejector levers and pivot them inward toward the handle in

the card carrier until they are flush against the front edge of the card carrier.

For easier installation, install both LCC fan controller cards before you tighten the fasteners.

Note

Step 8

Use the screwdriver to turn the two captive screws on the front panel of the LCC fan controller card clockwise to seat

the card firmly in the slot.

What to do next

After performing this task, place the impedance carrier in an antistatic bag for storage and future use. Close

the front (PLIM) side cosmetic doors and verify that the card has been installed properly

Installation of an LCC Fan Controller Card, on page

system, install the route processors

installation of the LCC fan controller cards.