Cisco SRS Series Installation Manual page 86

Steps
Figure 36: Unscrewing Power Shelf Ejector Handle
1 Top mounting screw in handle.
2 Holes for the screw that attaches the power shelf to the mounting block though the handle.
Step 3 Using the screwdriver, unscrew captive screw on the left and right handles (see previous figure).
The handles will fall down and slightly away from the shelf.
Note
Figure 37: Mounting Handle Fallen Away from the Shelf
1 Initial position, with handle in place against power shelf
2 Handle pulled down for removal of power shelf
Step 4 Grasping both handles simultaneously, pull both the left and right handles down at the same time to pull the shelf partially
out of the chassis.
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
66
Installing and Removing Power Components